ST7789V Display with MIPI DBI SPI

[nanangcreacoll]

I tried using ST7789V display with MIPI DBI device tree node, but still nothing on display. I tried with display sample (sample/driver/display). Is there something missing in MIPI DBI device tree node?

overlay:

/ {
	chosen {
		zephyr,display = &st7789v;
	};

	leds {
        compatible = "gpio-leds";
        lcd_backlight: lcd_backlight {
            gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
            label = "LCD Backlight";
        };
    };

    mipi_dbi {
        compatible = "zephyr,mipi-dbi-spi";
        status = "okay";
        reset-gpios = <&gpio0 27 GPIO_ACTIVE_LOW>;
        dc-gpios = <&gpio0 31 GPIO_ACTIVE_HIGH>;
        spi-dev = <&spi0>;
        write-only;
        #address-cells = <1>;
        #size-cells = <0>;

        st7789v: st7789v@0 {
            compatible = "sitronix,st7789v";
            status = "okay";
            reg = <0>;
            mipi-max-frequency = <DT_FREQ_M(8)>;
            mipi-mode = "MIPI_DBI_MODE_SPI_4WIRE";
            width = <240>;
            height = <240>;
            x-offset = <0>;
            y-offset = <0>;
            vcom = <0x19>;
            gctrl = <0x35>;
            vrhs = <0x12>;
            vdvs = <0x20>;
            mdac = <0x00>;
            gamma = <0x01>;
            colmod = <0x05>;
            lcm = <0x2c>;
            porch-param = [0c 0c 00 33 33];
            cmd2en-param = [5a 69 02 01];
            pwctrl1-param = [a4 a1];
            pvgam-param = [D0 04 0D 11 13 2B 3F 54 4C 18 0D 0B 1F 23];
            nvgam-param = [D0 04 0C 11 13 2C 3F 44 51 2F 1F 1F 20 23];
            ram-param = [00 F0];
            rgb-param = [CD 08 14];
        };
    };
};

prj.conf

CONFIG_HEAP_MEM_POOL_SIZE=16384
CONFIG_LOG=y
CONFIG_DISPLAY=y
CONFIG_DISPLAY_LOG_LEVEL_DBG=y
CONFIG_MIPI_DBI_LOG_LEVEL_DBG=y